Arcam 290 - Delta 290 P Front Panel Controls; Speaker Output Selection (SP1;SP2); Headphone Socket and Power Controls

FRONT PANEL
The Delta 290P can drive two pairs of
loudspeakers, simultaneously if required,
providing both pairs are rated between 8 and
16 ohms. Either pair can be selected using
the switches labelled SP1 and SP2 on the
front panel. To avoid overheating, the
combined load impedance as seen by the
amplifier should not fall below 4 ohms per
channel.
CONNECTING YOUR SOURCE
COMPONENT
® PWR AMP IN -Connect to your pre¬
amplifier outputs.
® PREAMP OUT: The 290P can be
connected to provide two mono outputs
from a single input. Using the U-link ®
supplied, connect the PREAMP OUT
sockets © together.
Utilising one Delta 290P per loudspeaker in
this manner will allow bi-amplifying of bi-
wireable loudspeakers. This is particularly
beneficial for top quality stereo installations
with a separate pre-amplifier, or for the left,
centre and right channel loudspeakers in a
five speaker Dolby Pro Logic system.
Contact your Arcam dealer for more
detailed information.
» Daisy Chain - The Delta 290P is capable
of driving further Delta 290P amplifiers (or
any other power amplifier), to drive more
speakers (eg. those in other rooms or tri-
amplified speakers etc). Connect the extra
power amplifier inputs to the PREAMP
OUT outputs ® left to left, right to right.
t,® SP1 and SP2 - Pressing the SP1 switch turns
on the speakers connected to the SP1
(upper) set of output terminals on the rear
panel. Similarly the SP2 switch turns on the
speakers connected to the SP2 (lower) set of
output terminals.
■ Both the SP1 and SP2 switches can be
turned on at the same time, provided that
the combined impedance of the two pairs of
speakers does not fall below 4 ohms per
channel.
Important note: If both switches are turned off
then the amplifier will appear not to be
functioning, as all speakers will be switched off!
© HEADPHONES SOCKET - Accepts
headphones rated between 8ohms and
2kohms fitted with a 6.3mm stereo jack
plug. If your headphones are fitted with a
different plug contact your dealer for a
suitable adaptor.
■ The headphone socket is always switched
on, irrespective of the positions of switches
© and ©.
© POWER - Switches the power on and off.
© POWER LED - This will initially glow
amber. After a few seconds, it will glow
green. When the LED glows amber, the
speakers are disconnected and an internal
protection circuit is activated.
■ If this LED glows amber during normal use
it may be due to the amplifier overheating or
an output overload. Check the amplifier is
properly ventilated. Switch the amplifier off
and wait for 2-3 minutes before switching
on again.