Arcam AVR10 - Host Version 0 v82;09; Fix List for Host Version 0 v82;09

23425
AVR10/AVR20/AVR30/AV40 Software Release Notes
– 17 –
Arcam, The West Wing, Stirling House, Waterbeach, CB25 9PB, UK
Host Version 0v82/09
LCD/IAP 0.36/0.04
DSP1 02.01 / 01.07
DSP2 00.01 / 00.10
DTS 3.90.35.00
OSD 0.03
DAB 303 / 561
NET 0.100.239
BT 0.5 (or 0.7 depending on build)
Fix list:
20828: PCM 2.0 @ 96kHz/192kHz sometimes not recognized correctly.
20893: OSD with Dolby Vision content shifted on some displays.
20903: Play Atmos, play internal test tones, audio does not return.
20904: Test tones did not work after playing Atmos stream.
20914: Analogue input trim optimised.
20939: Zone 2 audio out “follow zone 1” no output.
20950: Zone 2 inputs not changing with simulated IR over RS232/IP.
20954: DTS:X to DTS HD MA 2.0 exchange causes audio artefact.
20972: Dolby digital incoming format display changed with different speaker setups.
20982: Correct MQA Studio icon text size.
21004: IP/RS232 command supports 4 digit PIN for secure backup.
21018: Restore backup to USB could cause lockup with some USB sticks.
21019: Store backup to USB could cause lockup with some USB sticks.
21025: IP/RS232 requesting input config too soon after input change should return 0x85 until ready.
21044: PCM > MCH > Dolby Surround causes audio artefact.
21047: Input trim could not be selected if source changed from digital to analogue.
21048: Volume setting for zone 2 could not be adjusted if selecting zone 2 with AMP+OK on remote.
21061: Turn on Zone1, then Zone2, turn off Zone1 & Zone2, turn on just Zone2, HDMI may not start.
21063: Network may not function if both Zone1 & Zone2 select network input.
21065: Startup OSD not centered on some displays at turn on.
21072: Implement DTS Virtual:X