EN-7EN-7
Keep circuit boards in their original packing until ready for use.
Avoid having plastic, vinyl or styrofoam in the working area.
Wear an anti-static wrist strap.
Discharge personal static before handling circuit boards.
Remove and insert circuit boards with care
When removing circuit boards, handle only by non-conductive surfaces. Never touch open-edge
connectors except at a static fre work station.
Minimize handling of circuit boards.
Handle each circuit board by its edges.
Do not slide circuit boards over any surface.
Insert circuit boards with the proper orientation.
Use static shielded containers for storing and trasporting circuit boards
Electrostatic Discharge (ESD) Precautions
To Next Page
Loading...
