Arcam SoloBar User Manual

E-21E-20
English
HDMI Setup HDMI Audio Out
Disable g Passthrough
Use the and buttons to switch HDMI Passthrough on
and off. HDMI passthrough passes the video and audio signal
from any HD source to your Solo bar via an HDMI cable.
The Solo bar splits the signal, playing the audio from the HD
source through its own speakers and sending the unaltered
video signal to a TV using an HDMI OUT cable. Press to
go back a level or to exit setup.
CEC / ARC
Enable g Disable
Use the and buttons to switch CEC/ARC on or off.
See page16 for more information. Press to go back a level or
to exit setup.
HDMI setup menu
Default settings are shown in Blue.
rmware update
Download an update file
To perform a rmware update, you’ll need
to download an update le from the Arcam
web site.
Check the availablity of rmware updates by
typing www.arcam.co.uk into your browser
and navigating to the Solo bar page.
Note: Make sure you download the file to the
root of your USB, do not put it inside a folder
or the update will fail.
Performing the update
Make sure the soundbar is turned on at the
plug and in standby mode.
Press and hold the and buttons
simultaneously for about ve seconds.
e Solo bar will turn on and display the
following information:
ARCAM SB M:V024
B:40526 D:30304
Note: M = Main software version,
B=Bluetooth software version and
D = DSP software version.
Press the button to go to the soware
update screen.
e display will change to:
System Update
Insert USB...
Note: Pressing IN- again will cycle between
this and the software version screen.
Insert the USB drive containing the update
le into the UPGRADE socket on the rear
panel of the Solo bar.
e rmware update will
start automatically once
the USB drive has been
detected and the display
will change accordingly:
System Update
Updating...
If 30 seconds have elapsed before the USB
was inserted, the display will timeout and
change to:
System Update
USB Not Detected
is message will be displayed for about
three seconds, aer which the Solo bar will
turn itself o and the entire procedure will
need to be repeated.
If the update was successful, the display will
show the following information for about
three seconds, aer which the Solo bar will
turn itself o.
System Update
Complete
If the update was not successful, the display
will show the following information for
about three seconds, aer which the
Solo bar will turn itself o and the whole
procedure will need to be performed again.
System Update
Error

Arcam SoloBar Specifications

General

Brand	Arcam
Model	SoloBar
Category	Speaker System
Language	English