47
2. Loosen the drain screw and allow the
gasoline and condensation to flow out.
3. Tighten the drain screw securely and
remove the hose.
Electric Fuel Pump
(450)
An electric fuel pump is incorporated in
the gas tank to deliver gasoline to the fuel
injector. The fuel pump is activated when
the ignition switch is in the ON position.
NOTE: Both the ignition and fuel
pump functions will be interrupted
by the Tilt Sensor if the ATV tips over
past 60°-70°. Righting the ATV will
reactivate the ignition and fuel pump.
Oil Level Stick
ATV-0100AA
KC0051A
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
NOTE: The ATV should be on
level ground when checking the
engine oil level.
1. Unscrew the oil level stick and wipe
it with a clean cloth.
2. Install the oil level stick and thread it
into the engine case.
3. Remove the oil level stick; the
engine oil level should be above the
“L” mark but not higher than the “F”
mark.
Seat Latch
AL676A
1. To remove the seat, lift up on the
latch release (located at the rear of
the seat); then raise the rear of the
seat and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on
the rear of seat. The seat should
automatically lock into position.
! WARNING
Do not drain float bowl contents directly
onto the engine. Gasoline is highly
flammable and could ignite. Use a hose.
! WARNING
It is very important that the drain
screw be tightened securely. If it is
not tightened securely, gasoline
could drip onto the engine.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
above the “L” mark but not higher
than the “F” mark.
! WARNING
Make sure the seat is secure before
mounting the ATV. Serious injury
may result if the seat is not properly
secured.
To Next Page
Loading...
