24
NOTE: The differential lock is
intended for use where minimum
traction is available. Steering effort
will increase with the front differen-
tial lock engaged. Maneuverability
and handling characteristics will
differ with the differential lock
engaged.
Foot Brake
The foot brake is the only service brake,
and it should be applied whenever brak-
ing is needed.
Apply the brake by pressing the brake
pedal down.
Steering Wheel Tilt Latch
Pull on the lever located on the steering
column and move the steering wheel to
the desired position; then release the
lever and make sure the steering wheel
locks securely.
WT002A
PR880A
Headlight Switch
PR883A
With the ignition switch in the LIGHTS
position, use the headlight switch to
select light bar, light bar with low beam,
or light bar with high beam.
Reverse Override Switch
This vehicle is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch located on the
center console.
NOTE: The vehicle must be in 4WD
to activate the reverse override.
Accelerator Pedal
Press down on the pedal to increase
engine RPM and vehicle speed; release
the pedal to decrease engine RPM and
vehicle speed.
NOTE: This vehicle is equipped
with an RPM limiter that retards
ignition timing when maximum
RPM is approached. When the RPM
limiter is activated, it could be mis-
interpreted as a high-speed misfire.
! WARNING
Make sure the steering wheel is locked
securely in place before moving the
vehicle, or steering wheel movement
could occur causing loss of control.
! WARNING
Make sure the steering wheel is locked
securely in place before moving the
vehicle, or steering wheel movement
could occur causing loss of control.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control could result. Use caution
when using the override switch as
reverse speed can greatly increase.
To Next Page
