50
3. Elevate the vehicle.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
7. Install the wheel and tighten the
wheel nuts in 20 ft-lb increments to a
final torque of 40 ft-lb (steel wheel),
60 ft-lb (aluminium wheel w/black
nuts), or 80 ft-lb (aluminum wheel w/
chrome nuts).
8. Remove the jack.
Muffler/Spark Arrester
(Prowler)
The muffler has a spark arrester which must
be periodically cleaned. At the intervals
shown in the Maintenance Schedule, clean the
spark arrester using the following procedure.
1. Remove the cap screws securing the
spark arrester assembly to the muf-
fler.
PR879
2. Using a suitable brush, clean the car-
bon deposits from the screen taking
care not to damage the screen.
NOTE: If the screen or gasket is
damaged in any way, it must be
replaced.
3. Install the spark arrester assembly
and secure with the cap screws.
Tighten to 60 in.-lb.
Muffler/Spark Arrester
(HDX)
The muffler has a spark arrester which
must be periodically cleaned. At the
intervals shown in the Maintenance
Schedule, clean the spark arrester using
the following procedure.
1. Open the cargo box and remove the
two springs securing the muffler to
the exhaust pipe.
2. Remove the muffler by pulling it
rearward out of the vehicle.
3. Remove the three cap screws secur-
ing the spark arrester assembly to the
muffler.
HDX243A
4. Using a suitable brush, clean the car-
bon deposits from the screen taking
care not to damage the screen.
HDX242
NOTE: If the screen or gasket is
damaged in any way, it must be
replaced.
! WARNING
Wait until the muffler cools to avoid
burns.
! WARNING
Wait until the muffler cools to avoid
burns.
To Next Page
Loading...
