10
CAUTION!
Do Not turn on power
to the spa until the spa
is filled to the required
level. Running the spa
pump without water
could cause immediate
damage and invalidate
your warranty!
CAUTION!
If your spa or AWP is equipped with Spa Boy
or ONZEN please consult the: Spa Boy Owners
Manual or ONZEN User Guide for further setup
requirements. If you do not have a copy, they
can be down loaded from the following link
http://www.arcticspas.com/support/down-
loads-manuals-brochures/ or go to www.
ArcticSpas.com
When the water temperature climbs above 85ºF (29ºC), proceed to the next step.
9) Test and Adjust Sanitizer level (Chlorine ideal 1 - 3 ppm or Bromine ideal 3 - 5 ppm).
10) Rotate diverters to centre position and press “Pump 2” button on topside control
panel for 5 seconds to activate the “Boost filtration system”. When this system is enabled,
“boo” is displayed on the screen. This will give 45 min of circulation and filtration to
disperse the chemicals.
11) You can set the temperature (between 38°C and 40°C or 100°F to 104°F) by pressing the
TEMP ( ) and TEMP ( ) buttons on the control panel. The spa will normally come
up to temperature within 16 to 24 hours. Replace the spa cover while the temperature is
reaching the set point.
IMPORTANT: For safety, you can lock your desired temperature setting.
Refer to the Topside Control Panel section for details.
To Next Page
Loading...
Need help?
General
