Arctic Spas Beauport User Manual

A. Add sanitizers until levels are up to the recommended levels
B. Replace test kits at least once a year
C. Chlorine/Bromine level very high and is bleaching test reagent, Allow sanitizer levels to recede by
opening cover and running jets.
A. Add Arctic Pure
®
Adjust Up until level reads 7.2 - 7.6 ppm
B.
Add Arctic Pure
®
Refresh, add Boost or Peak Boost.
C. Change from Bromine to Chlorine or vice versa.
D. Drain and refill spa.
A. Check pH and adjust as required.
B. Shock with Arctic Pure
®
Refresh, add Boost or Peak Boost dependent on whether you have a chlorine or
bromine system
C. Dilution of water will reduce contaminants and odor.
D. Check any ozone system is operational
A. Drain partially, add Arctic Pure
®
Best Defence, correct pH level to 7.2 - 7.6 and alkalinity to 100-130 ppm.
A. Squirt Foam Dissolve
TM
on foam. Refer to pg 20 for more information. (not with disposable filter)
A. High concentration of oils and organics being agitated by the jets and/or
Therapy Air
A. Use Arctic Pure
®
Best Defence and have your dealer check your water balance
B. Add Arctic Pure
®
Boost treatment to raise chlorine levels and test chlorine levels or for Bromine system add
Peak Boost & test Bromine levels
C. Stop the use of fragrance
A. Dirty filter, clean with Arctic Pure
®
Filter Restore (not with disposable filter). Increase Filter cycle.
B. Add Arctic Pure
®
Easy Clear
C. Shock treatment with Arctic Pure
®
Refresh
D. Add Arctic Pure
®
Adjust Down until level reads 7.2-7.6
E. Add Arctic Pure
®
Adjust Down to adjust TA level to 100-130 ppm
F. Shock treatment until combined chlorine is eliminated (see container instructions)
G. Empty spa and refill
H. Add Arctic Pure
®
Best Defence until level reads 100-280 ppm
SOLUTIONS
26

Arctic Spas Beauport Specifications

General

Brand	Arctic Spas
Model	Beauport
Category	Hot Tub
Language	English