Question 6 If the Spa Boy System is not working, can I add Arctic Pure BOOST or other sanitizer
to the spas water?
Yes you can add Arctic Pure BOOST if needed.
Arctic Pure BOOST or other chlorine sanitizer shouldn’t need to be added regularly to keep up with regular bather load.
Adding Arctic Pure BOOST or other chlorine sanitizers will raise sanitizer levels above the Spa Boy Systems maintained chlorine/ORP
optimum range (545mV-550mV) causing the Spa Boy System to shut down until the chlorine/ORP reading is below the optimum
range, 545mV/ORP.
• Adding BOOST can temporarily “poison” the SpaBoy sendor for 24-48 hours.
Do not trust the ORP reading until water has stabilized.
Question 7 Is it permitted to add Arctic Pure Refresh directly to the spas water?
Yes it is required to add Arctic Pure Refresh directly to the spas water.
At a minimum 1 capfull per week should be added for a spa and 2 caps full for an AWP.
Reduced amounts of Arctic Pure, Refresh can be used in spas equipped with an Arctic Spas OZONE System such as Peak 1 or Peak 2.
Arctic Pure Refresh has little effect on the Spa Boy Sensor Probe
Spa Boy Owners Manual
1.15 Caring for your Spa Boy System
Spa Boy Maintenance
73
To Next Page
Loading...
Need help?
General
