Arctic Spas Y Series - Page 25

24

 Series Techoo

Problem
solved.
ae an error
messages
  etc.
appeared on
epad displa
yes
no
erify if low-level
programming is set
properly.
Does Pump 2 or
Blower indicator
appear on epad
displa hen ou
press Pump  or
bloer e
efer to specic
section indicated
b error message.
yes
no
Replace
keypad.
no
Replace
Blower fuse.
s there stll a
problem
s Pump 
or bloer
oring
yes
If still not
working
replace
spa pack.
no
Measure
voltage on
the board.
Do ou
get a 
 reading
or  
for a  
pump
yes
no
Replace
spa pack.
yes
f Pump 2 or blower is not working,
follow this troubleshooting ow chart:
Pump 2 or blower doesnt work / ow chart  stepbystep

Pump 2 or blower
is not working
 Check for an error
message on keypad
display. If there is one,
refer to the specific
section indicated by
the error message.
 erify low-level
programming
configuration.
 If Pump 2 or Blower indicators do not appear,
use a spare keypad to verify if keypad is defective.
If it is, replace keypad.
If not, replace spa pack.
 If Pump 2 indicator appears when Key 2 is pressed,
verify if pump works in either speed
(if dual speed pump).
 erify if Pump 2 or
Blower indicator
appears on keypad
display when you press
Key 2 button.
StepbyStep
Replace
Pump 2 or
blower.
Check
wiring and
plugs.
Replace if
needed.