Arctic Spas Y Series - Page 27

26

 Series Techoo

f circulation pump is not working,
follow this troubleshooting ow chart:
Circulation pump doesnt work / ow chart  stepbystep
erify if low-level
programming has
been configured
properly
yes
Do ou read
  for a  
ir. Pump or 
 for   on the
connector 
no
Replace
Accessory
Fuse
Replace spa pack
if you still aren’t
getting a voltage
reading.
StepbyStep
f circulation pump is not
working:
 erify low-level
programming
configuration.
 Start circulation pump
by setting temperature
set point 2 °F higher
than actual water
temperature.

 If you dont get a
voltage reading,
replace the accessory
fuse.
 If changing the fuse
does not fix the
problem, replace the
spa pack.
 If voltage is as it should
be, replace circulation
pump.
 Ta k e voltage reading
on the corresponding
AMP connector:
Pin 1  Pin 3
our reading should be:
240  for
a 240  pump
120  for a
120  pump
Flow chart
Pin 
Pin 1
Circulation pump fuse (F21)
Replace
Cir. Pump.
Check
wiring and
plugs.
Replace if
needed.
Circulation pump fuse (F2)
Pin 
Pin 1
in.ye model
in.yt model