ARDETEM DIP 10 - 4.6.4 Display Features; Display Point and Resolution Settings; Response Time and Brightness Adjustment

• Inhibition of the last digit (bottom weight)
In the mode programming, the menu L.dIG allows suppressing the dis
-
play of the last digit, the latter being enforced to 0 if OFF is validated.
• Deleting of the unsignificant zeros
Suppresses the display of the unsignificant zeros
on the left hand side.
Eg.: Display value 0015
Display = 0015
Display = 15
Eg.: Display value 00.15
Display = 00.15
Display = 0.15
4.6.4 Display features:
Place of the decimal point for the inputs other than tempe-
rature inputs
Display resolution for the temperature inputs: 0.1° or 1°
Display corresponding to the input down scale
(except the temperature input)
Display corresponding to the input down scale
(except for the temperature input)
Only for the inputs process, resistance, potentiometer,
expressed in display points.
− If the display full scale > display down scale and if the display is ≤ to
the cut off value, then it will be held at down scale.
− If the display full scale < display down scale and if the display is ≥ to
the cut off value, then it will be held at down scale.
• Response time
:
Integration indice of the digital filtering:
Programmable from 0 to 10; for use in case of unsteady input signal.
To obtain the maximum response time, add 240 ms.
Note: For the response time of the analog output, add 40ms to the
values shown in the table.
For the relays : add the time delay programmed on the alarms.
• Setting of the digits brightness
Lowest brightness Strongest brightness
p14
br.diG
1 1 1 1
4444
L.dIG
nuLL
nuLL
YES
Point
rESOL.
d.diSP
F.diSP
Cut.oF
intEG
=
nuLL
no
YES
=
=
nuLL
no
YES
=
=
Typical response
time at 90%
120 ms 400 ms 600 ms
intEG 0 1 2
1 s
3
1.4 s
4
2 s
5
3 s 5 s 7.5 s
6 7 8
10 s
9
15 s
10
4.7 Reading of the configuration
Reading of the input parameters
Reading of the measure display parameters
Reading of the analog output parameters
(if option analog output)
Reading of the alarm parameters
(if option relay outputs)
Reading of the safety parameters for sensor
rupture or self-diganosis of the outputs
Reading of the display programming
parameters
Reading of the instrument internal parameters
In each reading submenu, use keys and to move, and key
to visualise the parameters.
If no key is pressed during 20 s., the instrument will revert to the
measure display.
rEAd
rEAd
InPut
diSPL
AnA.
Pr.diS
About
Validation /
vertical move
rELAY
SECU