ARDETEM DIP 10 - 4.4.1 Programming of the Input; Process Signals Configuration

Note:
⇒ In mode programming, the instrument will automatically revert to measure
with the former configuration if no key is pressed during 1min.
p6
InPut
4.4 Programming menu (according to options)
diSPL.
AnA.
rELAY
SECU
Pr.diS
Access to the programming of the input p6
Access to the programming of the display factor
p8
Access to the programming of the analog output
p8
(option analog output)
Access to the programming of the relays p9
(option relay outputs)
Access to the programming of the outputs, the relays p9
in case of error self-diagnosis and/or sensor
rupture, and access to disconnecting the sensor rupture
(option analog or relay output)
Access to the programming of the display
p10
Access to the programming exit menu with
p10
or without saving of the configuration
M
Move through the menus / choice
Upwards move / increase
Downwards move /
decrease
Validation / vertical move
Menu exit / access
M
Note:
Press
to go on to next menu
SAvE
InPut
4.4.1 Programming of the input
a. Process signals
voltage input
voltage input only
choice of the caliber
to t° sensors
resistive sensors
«
100M
«
«
U
«
InPut
300U1U
10U
current input
«
MA
2.UirE
yES
no
«
tyPE
«
CALib
diSPL.
Connection of the mA
sensor:
Choose if a
mA passive sensor
is to be connected
between terminals 5
and 8 (2-wire
transmitters)
YES