ARDETEM DIP 10 - 4. PROGRAMMING; 4.4 Programming Menu Overview

p5
4. PROGRAMMING
4.1 Communication with the instrument
Several functions can be reached directly on the front panel:
4.3 Main menu
4.2 Orientation through the programming
The dialogue is ensured by 4 keys located on the front face.
Move through the menus:
downwards, or decrease
the value shown
Validation of the displayed
parameter, or access to a submenu
Exit from a submenu to access
next menu / access to the pro-
gramming exit menu
Note: In mode programming, the istrument will automatically revert to
the measure with the former configuration if no key is pressed during
1min.
Move through the menus:
upwards, or increase the
value shown
Display of
the max.
value p17
0 reset of the
min. and max.
p17
Access to the
main menu p5
If code correct,
access to the
programming
menu
(see p6)
Further functions can be reached by pressing several keys simulta-
neously:
Reading convention:
Move through the main menu
Revert to previous menu
Blinking display: awaiting validation or setting
Alternating information display
Entering of a parameter:
First start by increasing or decreasing
the 1st digit and the sign: from -9 to +9.
the 2nd from 0 to 9.
the 3rd from 0 to 9.
the 4th from 0 to 9.
M
M
Alarms
Led 1
Led 2
Display of the
measure
M
M
+
M
+
M
+
+
and
6888
6588
6528
6520
«
scroll
menus
vertical
move
Between each entering, validate
the cipher with key
Display of
the min.
value p17
If code
incorrect,
message
appears
no
Entering of the access code
The access to the programming
menu is protected by a 4-cipher
code.
On factory exit, the code is 0000
(to change the code, see page
15).
Setting of the display down scale; (see p17)
Setting of the display full scale; (see p17)
Visualisation of the direct measure; (see p18)
Visualisation and setting of the alarm setpoints; (see p18)
Mode reading
of the
configuration
(see p14)
Simulation
of the ana-
log output
(see p16)
Authorized by
access code
Deleting of
the recorded
alarms
(see p16)
rEAd
ProG
CodE
8 888
GEnE. CLEAr
«
«
«
«
«
Programming
of the access
code
(see p15)
Simulation of
the display
(see p15)
Authorized by
access code
(relay/analog
outputs)
(analog
output)
(inputs process,
resis., potent.)
(relay output)
P.CodE
SIMUL
«
«
0 reset of
the function
TARE
(see p16)
Authorized by
access code
CLr.tA
«