Argo 2S - 地基 電源供給 Foundation Power Supply

CH3 安裝 Installation Original
21
3.4 地基、電源供給 Foundation Power supply
地基 Foundation
所有銑床應以螺栓鎖於一混凝土地基，本機器應
安裝於固體水平地板或防振墊片上以防止任何
震動所產生的移動。
Ideally all milling machines should be bolted to a
concrete foundation. The machines however should
be placed on a solid level floor or anti-vibration
pads to prevent any rocking movement.
電源供給 Power supply
(1) 檢查馬達電源之電壓。
Check motor voltages against supply.
(2) 確使電源連接符合當地安全規章。注意當未
裝控制盤時，頭部開關無過負荷保護作用。
Ensure that the supply is connected to comply
with the local safety regulations. Note the
Head switch has NO overload protection,
when a control panel is not fitted.