Argo Conquest Series - Assembling and Installing the Muffler Assembly (Conquest Models); Conquest Model Muffler Assembly Installation

Argo Service Manual Ducting & Exhaust
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
DE-5
DE-10 DE-11
Disassembling the Muffler Assembly (Conquest Models)
1. On a clean work surface, remove the single fastener and spacer securing the heat
shield to the muffler assembly. Photo DE-11
2. The above heat shield removed exposes another fastener securing the muffler to the
shrouding. Remove this fastener. Photo DE-12
3. Flip the assembly over and remove the 2 fasteners securing the muffler on the other
side of the shield assembly. Photo DE-13
DE-12 DE-13
4. Slide the muffler assembly from the heat
shield. Photo DE-14
DE-14
5. Remove the fastener securing the
tailpipe and spark arrestor and pull the
tailpipe from the muffler assembly.