8. Rated value of battery
9. Measured value of battery
10. ‘Start engine’ prompt (Start)
11. ‘Enter’ prompt (Enter)
12. Test standard
13. Selected Voltage
14. Alternator Pass/Fail icon
Input keys
A. Enter/Print, [enter/print]
B. Browse up, [>]
C. Browse down, [<]
Basic Tester Operation
1. Connect test clamps to battery.
2. Select Voltage: Use [>] or [<] to select Voltage, press [enter/print].
3. Select Test Standard: Use [>] or [<] to select test standard, press [enter/print].
4. Enter Battery Rating: Use [>] or [<] to select rated value of battery, press [enter/print].
5. Follow (Start) and (enter) icons to complete testing.
6. Press [enter/print] to view results screens. Press [>] or [<] to view detailed results within a test screen.
7. Press and hold [enter/print] to print/save results (printer module must be connected).
More: Performing a Battery Test
Basic Tester Setup
Follow these steps to set the date / time and other tester preferences.
The tester must be connected to a battery during setup.
If you make a mistake, disconnect, re-connect and enter SETUP mode again.
The printer does not need to be connected to the tester to complete any setup operation.
Enter SETUP mode
To Next Page
Loading...