Argus Analyzers » CD Home » User Manual » Printing and Saving Test
Results
User Manual: AA360, AA1000
PRINTING AND SAVING
RESULTS
If the AATPR20 printer is attached to the tester, results may be printed or saved any time after initiating a battery test.
Press and hold
[enter/print] to output results to the printer and memory.
Setup Output Preference
The preference to print, save, or both print AND save the results is made in Tester Setup Options. To change the output
preference, enter SETUP mode, and advance to the ‘Output Mode’ page.
After completing a test, press [enter/print] button to change the display to the ‘SoC’ page. From the ‘SoC’ page, press
and hold [<] for 3 seconds (until beep). The display will clear and the first setup page, ‘Prn’ is displayed. Press
[enter/print] 8 times to advance to the Output Mode page (‘P – S’).
Use [>] or [<] to set Output mode preference.
Select ‘P’ = print only;
Select ‘S’ = save only; or
Select ‘P – S’ = print and save.
Press [enter/print] to confirm your selection and return to the normal display.
To Next Page
Loading...