After completing a test, press [enter/print] to change the display to the ‘SoC’ page. From the ‘SoC’ page, press and hold
[<] for 3 seconds (until beep). The display clears and the first setup page, ‘Prn’ is displayed. At each setup page,
change the value using [>] or [<], and confirm the value by pressing [enter/print]. After the last setup screen (P-S), all
setup values are stored and the tester returns to normal mode.
Each screen is identified at the top left of the display in order:
1. ‘Prn’ Set Printer language, see table below.
2. ‘Yr’ Set Year.
3. ‘Dat’. Date - set day first, then month.
4. ‘ti’. Time - set hours first, then minutes.
5. ‘Ey’. Easy test mode - select ‘On’ or ‘Off’
6. ‘P-F’. Pass / Fail mode – ‘On’ or ‘Off’.
7. ‘P-S’. Output mode - P=Print, S=Save. Select ‘P’ or ‘P-S’ or ‘S’.
Note: To skip any setup page without making any changes, press [enter/print] to advance to the next page.
More: Tester Setup Options
Printer Language Selection
The AATPR20 can print in 22 languages. The default language is ENGLISH. On the ‘Prn’ page of the setup mode,
select the number for desired language.
1 English
2 French
3 German
4 Dutch
5 Spanish
6 Portuguese
7 Italian
8 Swedish
9 Czech
10 Hungarian
11 Polish
12 Turkish
13 Danish
14 Finnish
15 Russian
16 Japanese
17 Chinese
18 Korean
19 Croatian
20 Greek,
21 Bulgarian
22 Slovenian
Test Report Headline Text
The AA360 and AA1000 series testers allow the user to program up to three lines of custom text to be printed at the top
of the test report. Use the Argus Data Manager Software to set the test report headline text for your tester.
More:
To Next Page
Loading...