8. Swedish
9. Czech
10. Hungarian
11. Polish
12. Turkish
13. Danish
14. Finnish
15. Russian
16. Japanese
17. Chinese
18. Korean
19. Croatian
20. Greek
21. Bulgarian
22. Slovenian
SETUP Page 2: ‘Yr’ Set the present year.
Use [<] and [>] to select the number for desired year. Confirm the selection by pressing [enter/print].
SETUP Page 3: ‘Dat’ Set the date.
Use [<] and [>] to select the number for the current day of the month. Confirm the selection by pressing [enter/print].
Use [<] and [>] to then select the number for the current month. Confirm the selection by pressing [enter/print].
SETUP Page 4: ‘ti’ Set the current time.
Use [<] and [>] to select the number for the present hour of the day. Confirm the selection by pressing [enter/print].
Use [<] and [>] to then select the minutes. Confirm the selection by pressing [enter/print].
SETUP Page 5: ‘Ey’ Easy Test mode. Select ‘On or ‘Off’ (default.)
Easy Test mode is designed to reduce the number of entries that must be made prior to each battery test. When Easy
Test mode is turned ‘On’, the tester will NOT prompt the user to select ‘voltage’ or ‘rating standard’ prior to each test.
The tester will use the ‘voltage’ and ‘rating standard’ values selected for the PREVIOUS test. This mode is particularly
useful if the tester is being used to repeatedly test batteries of the same voltage and rating standard.
Before setting Easy Test mode to ‘On’, be sure to perform a battery test using the selections for voltage and rating
system that you wish to choose automatically for subsequent tests. Use [<] and [>] to select ‘Easy Test’ mode ‘on’ or
‘off’. Confirm the selection by pressing [enter/print].
SETUP Page 6: ‘P-F’ Pass / Fail mode. Select ‘On’ or ‘Off’ (default.)
Pass/Fail mode is designed to provide ‘Pass’ or ‘Fail’ only test results whenever a reliable Battery Life / State of Health
test result is determined. When ‘Pass / Fail’ mode is turned ‘Off’, there is a range of Battery Life / State of Health
results that are interpreted as ‘Warning’ and trigger a recommendation of ‘Replace Soon’. This recommendation
indicates that the battery has not yet reached end of life, but replacement should be considered soon. When ‘Pass / Fail’
mode is turned ‘On’, all results in the ‘Warning’ range are reported as ‘Pass’.
Pass / Fail mode may be useful when the tester is primarily used to determine the performance of batteries for warranty
To Next Page
Loading...