Use [<] and [>] to select ‘Pass / Fail’ mode ‘on’ or ‘off’. Confirm the selection by pressing [enter/print].
SETUP Page 7: ‘P-S’ Output mode. Select P=Print, S=Save, or ‘P-S’=Print
and Save (default.)
To send the results to the printer only select ‘P’. To save results in memory only select ‘S’. To save results in memory
AND print select ‘P-S’.
When ‘P-S’ is selected, the printed report will include a form where the user can write information related to the test for
later reference. Saved test reports can be analyzed and stored on a computer using the Argus Data Manager software.
Use [<] and [>] to select the desired Output mode. Confirm the selection by pressing [enter/print].
Test Report Headline Text
The AA360 and AA1000 series testers allow the user to program up to three lines of custom text to be printed at the top
of the test report. Use the Argus Data Manager Software to set the test report headline text for your tester.
More:
Manual - Basic Operation
Manual - Tester Setup Options
Manual - Performing a Battery Test
Manual - Interpreting Test Results
Manual - Printing and Saving Test Results
Manual - Service and Troubleshooting
Manual - General Information
Manual - Argus Data Manager Software
Version 1.0
Copyright © 2011 by Argus Analyzers, 2/11
User Manual
Support
Argus Data Manager
Copyright 2008-2011 Argus Analyzers :: Terms of Use :: Privacy Policy
How to Buy
News Room
To Next Page
Loading...