EN - 16
Check Track Tension
(Model 921023)
Check tracking of unit and tension the tracks
as required (see Track Tension Adjustment
on page 37).
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Check
Auger Gearcase on page 27).
Check Engine Crankcase Oil
IMPORTANT: The engine may be shipped
with oil in crankcase. Refer to Engine Manual
for detailed instructions.
Fill Engine Fuel Tank
Fill fuel tank. DO NOT OVERFILL! See
FILLING FUEL TANK on page 23
If Applicable - remove the protective wrap
from the fuel tank and install the fuel cap
located in the attached bag.
Check Function of all Controls
Ensure unit runs and performs properly. Refer
to OPERATION on page 19.
Run-in Attachment Belt
1. Start unit in a well-ventilated area
ac
cording to Starting and Shut Off
on
page
24.
2. Engage attachment clutch lever and
run
at
tachment for about 15 minutes.
3. Stop unit, wait for all moving parts to
stop, and remove spark plug wire.
4. Adjust clutch idler according
to
At
tachment Clutch/Brake Adjustment
on
p
age 32.
5. Adjust belt finger, if necessary. S
ee
Chec
k Belt Finger Clearance
on
p
age 34.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a ti
re
wit
hout the proper equipment
and
experienc
e to perform the job.
• Do not inflate the tires above th
e
recom
mended pressure.
• Do not weld or heat a
wheel and
tire assembly. Heat can cause an
increas
e in air pressure resulting in
an explosion. Weld
ing can
st
ructurally weaken or deform t
he
wheel.
•
Do not stand in front or over t
he
t
ire assembly when inflating. Use a
clip-on chuck and extension ho
se
long enough
to allow you to stand
to one side.
To Next Page
Loading...
