Aries 1110310 User Manual

PAGE 1 • 1110310-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Level of Difficulty
Easy
Parts List
2 Headache rack tie down
2 Threaded knob, M8
2 Hex bolt, M8 - 1.25 x 20mm
Scan
for helpful
install tips
INSTALLATION MANUAL 1110310
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Caution: Failure to follow the guidelines below and on page 2 may result in damage
or loss of load. This includes, but not limited to, damage to tie downs, headache
rack and vehicle. It is the drivers responsibility to ensure the load is secure and to
periodically check to make sure the load remains secure.
Headache rack tie downs are designed to withstand
150 pounds of straight line tension force.
Any hooks placed into tie downs must be small enough
to fit completely into holes or slots and and should also rotate freely.
Tie downs should not be used to secure loads in the bed of pickup truck or any
other place that would cause the tie downs and headache rack to be side loaded.
Tie downs should only be used to secure loads on top of headache rack.
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.
Caution: Do not use in this manner

Aries 1110310 Specifications

General

Brand	Aries
Model	1110310
Category	Automobile Accessories
Language	English

Summary

Parts and Specifications

Parts List

Lists components for headache rack tie down installation, including tie downs, knobs, and bolts.

Torque Specifications

Provides recommended torque values for various bolt sizes (M6, M8, M10, M12, 1/4", 5/16", 3/8", 7/16", 1/2").

Important Usage and Safety Guidelines

Improper Usage Warning

Caution against using the tie downs in a manner that causes side loading or undue stress.

Load Capacity

Specifies that tie downs withstand 150 pounds of straight line tension force.

Hook and Load Placement

Details requirements for hooks and restricts tie down usage to securing loads on top of the headache rack.

General Cautions

Warns that failure to follow guidelines may result in damage to tie downs, rack, or vehicle.

Installation Steps

Step 1: Prepare and Insert Bolt

Place headache rack on a work surface and insert an M8 bolt into the top rail slot.

Step 2: Attach Tie Down

Align tie down with bolt, slide into place, thread knob, and tighten to secure.

Step 3: Complete Installation

Repeat steps for remaining tie downs and perform periodic inspections for tightness.