Aries 35-2000 - Installation Steps; Step 1: Remove Factory Tie Down; Step 2: Attach Mounting Brackets; Step 3: Mount the Bull Bar

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 877.287.8634 • 35-2000-INS-RA • PAGE 2
Step 1
Starting on the driver-side,
remove the factory tie down.
Step 2
Place the driver-side mounting bracket
up to the frame of the vehicle
and secure using the previously removed
factory hardware.
Repeat process on the passenger side,
reinstall the tow hook backwards on the
passenger-side.
Snug the hardware,
but do not fully tighten.
Step 3
Attach the bull bar to the mounting
brackets using two M12 x 50mm
hex bolts, two M12 lock washers
and two M12 flat washers.
Snug the hardware,
but do not fully tighten.
Step 4
Adjust and level the bull bar. With the
bull bar in the desired position, it is
recommended to tighten all brackets
to the vehicle first, followed by the
bull bar connections.
Congratulations on the installation
of your new ARIES 3" bull bar.
With the bull bar installed,
periodic inspections should be
performed to ensure all mounting
hardware remains tight.