To Next PageTo Next Page
Need help?Do you have a question about the Aries AL234046 and is the answer not in the manual?
General| Brand | Aries |
|---|---|
| Model | AL234046 |
| Category | Automobile Accessories |
| Language | English |
Identify and select the first, third, and fifth mounting tabs on the vehicle's bottom edge.
Secure a universal mounting bracket to the driver side body panel using an M8 hex bolt, lock and flat washer.
Rotate bracket, slide M8 clip nut onto mounting tab, and secure bracket with M8 bolt, lock and flat washer.
Repeat steps 2 and 3 to install the second bracket at the third mounting tab location.
Locate fifth tab, remove plug, insert clip nut, and secure bracket top with M8 bolt; repeat for bottom.
Position the side bar onto the mounting brackets, aligning mounting points carefully.
Fasten the side bar to brackets using M10 hex bolt, lock washer, and flat washer at each location.
Adjust and level the side bar, then tighten all vehicle brackets first, followed by side bar connections.
Repeat steps 1 through 8 on the passenger side for all brackets except the def-tank bracket.
Identify def-tank bracket parts for diesel models and locate the round factory hole in the rocker panel.
Insert the 10mm bolt plate into the rocker panel access hole and secure with a plastic retainer.
Connect the def-tank L-bracket to the bolt plate using M10 hex nut, lock washer, and flat washer.
Slide M8 clip nut onto mounting tab and fasten side bar bracket with M8 hex bolt, flat and lock washer.
Attach the def-tank support bracket to the def-tank L-bracket using an M10 hex bolt, flat and lock washer.
Complete installation by repeating steps 6 through 8 on the passenger side of the vehicle.
