Aries 35-2000 User Manual

PAGE 1 • 35-2000-INS-RA • 877.287.8634 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For stainless steel and aluminum, polish may be used to clear small scratches
and scuffs on the finish. Mild soap may be used also to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Level of Difficulty
Easy
Parts List
1 Bull bar
1 Driver / left
mounting bracket
1 Passenger / right
mounting bracket
2 Hex bolt, M12 x 50mm
2 Flat washer, M12
2 Lock washer, M12
Tools Required
Torque wrench Ratchet
Socket, 17mm Socket, 18mm
Scan
for helpful
install tips
INSTALLATION MANUAL 35-2000
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.

Aries 35-2000 Specifications

General

Brand	Aries
Model	35-2000
Category	Automobile Accessories
Language	English

Summary

Installation Notes and Maintenance

Installation Steps

Step 1: Remove Factory Tie Down

Starting on the driver-side, remove the factory tie down.

Step 2: Attach Mounting Brackets

Place driver-side mounting bracket to frame, secure with factory hardware. Repeat on passenger side.

Step 3: Mount the Bull Bar

Attach the bull bar to the mounting brackets using M12 hex bolts, lock washers, and flat washers.

Step 4: Adjust and Final Tighten

Adjust bull bar level, tighten brackets first, then bull bar connections. Perform periodic inspections.