35ExTensor
6.1.4 Handwheel
If the actuator is equipped with the "handwheel" option, it can be moved using the external handwheel when the power is off. To do
this, press in the handwheel and then turn it by hand. When doing this, turn with particular care in the areas of the end positions of
ttings, since high torques can be transmitted through the handwheel.
After the adjustment, the handwheel automatically disengages and jumps back to its original position. The handwheel does not turn
during normal operation of the actuator.
Turning is only permitted by hand.
The handwheel may only be used when the drive is de-energized (no voltage/no current).
Danger! On the back of the drive, there is a blind plug to close the handwheel option for
equipment variants without a handwheel. This may not be removed or altered.
To Next Page
Loading...
