What to do if the ARIS Controller shows a sensor fault?
If your ARIS Controller is displaying a sensor fault, disconnect the power supply and then re-energize it. If the error persists after re-energizing, further assistance may be needed.
Why am I getting a range error on my ARIS Tensor Zone 2/22?
A range error on your ARIS Controller indicates that the end positions are not adequately spaced. Ensure that the end positions are greater than 0.5 sensor turns apart, which corresponds to 28 degrees.
What causes a parameter error on the ARIS Tensor Zone 2/22?
A parameter error on the ARIS Controller may occur with free values if the difference does not cover at least 20% of the complete range. Ensure that the difference covers at least 20% of the complete range.
General| Brand | ARIS |
|---|---|
| Model | Tensor Zone 2/22 |
| Category | Controller |
| Language | English |
Explains hazard symbols and their significance, classifying risks according to ISO 3864-2.
Provides essential safety guidelines for installation, operation, and handling of actuators.
Outlines procedures and precautions for safe and accurate operation and system integration.
Instructions for the correct mechanical installation and mounting of the actuator.
Step-by-step guide for making the electrical connections to the actuator.
Provides schematic diagrams for AC and DC electrical connections.
Details the I-ACT (PMR) controller's wiring terminals and pin assignments.
Describes how to switch between and operate the actuator in Automatic and Hand modes.
Step-by-step guide to program the left and right end positions for the actuator.
Configures voltage or current values for positioning the motor.
Sets the actual feedback values for both end positions.
Shows circuit diagram and pin assignment for current output operation.
Guidance on diagnosing and resolving common issues and initiating repairs.
To Next Page
