ARIS Tensor Zone 2/22 - I-ACT (PMR) Setup Mode

25Tensor
8.2 Setup mode I-ACT (PMR)
Survey
The microprocessor controller I-ACT (PMR) can perform the following tasks:
• Set left and right end position
• Set handling shortly before reaching an end position and switching on and off of the motor
• Enter voltage and current values for the end positions
• Activate message output
By changing the switch from manual to automatic the setup mode is left without saving a
currently revised parameter value.
Start setup mode
1. Slide switch to „MANU“.
2. Hold down button [M] at least 2 sec.
The setup for parameter setting is turned on, the display shows the rst menu item.
E.L Setup mode active, 1. menu level in display.
To exit the programming mode, slide switch back to "AUTO".
ADVICE
!