13Tensor
The control terminals only have a function if the tensor electronics are operated without the
controller module I-ACT (PMR).
The drive must be permanently energized, otherwise the holding torque is not available!
5. Actuator operation without controller and display module (Standard)
5.1 Operation
5.1.1 Buttons and switches
The buttons (1) are marked with
LEFT [L]
MENU [M]
RIGHT [R]
Switch (2) changes between automatic and manual mode.
In MANU position the setup operation can be turned on
from manual mode by keystroke.
5.1.2 LED displays
The LEDs on the operation module show information by
ashing or blinking.
On/Off
Blinking
To Next Page
Loading...
Need help?
General
