39Tensor
12. Parameter RESET
The Parameter-Reset-Function is implemented in order to restore the factory settings.
Perform the Parameter-RESET:
• Switch into HAND-Modus in de-energized state
• Hold buttons L+R down
• Turn on power supply and hold buttons down
a) LED L+R blink slowly (approx. 4 s)
b) LED L+R blink fast (approx. 4 s)
c) LED L+R light permanently
• Release buttons
13. Required customer information
If it is not possibly to remedy the malfunction, please inform your ARIS contact person.
Advices at: www.stellantriebe.de
13.1 Troubleshooting and repair
Hazardous voltage: Possible stroke!
• Troubleshooting and repair only by experts!
• Cut off voltage before opening the actuator.
• Risk of crushing at rotating elements!
We recommend a repair at the ARIS factory.
More information under: www.stellantriebe.de
To Next Page
Loading...