Ariston E-Combi 30 - First Igniton Operation

29
commissioning
FIRST IGNITION OPERATION
1. Check the electrical supply.
Complete . . . . . . . . . . . . . . . . . . .
Date . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installer . . . . . . . . . . . . . . . . . . . . . . . . . .
2. Check the type of gas and
change the gas if necessary.
Complete . . . . . . . . . . . . . . . . . . .
3. Check the gas tightness.
Complete . . . . . . . . . . . . . . . . . . .
5. Check the exhaust ue.
See page 17
Complete . . . . . . . . . . . . . . . . . . .
6. Fill the installation.
See page 28
Complete . . . . . . . . . . . . . . . . . . .
7. Check the hydraulic water
tightness.
Complete . . . . . . . . . . . . . . . . . . .
8. Spin the pump.
Complete . . . . . . . . . . . . . . . . . . .
9. Set the heating power.
See page 31
Complete . . . . . . . . . . . . . . . . . . .
10. Set up heating controls
Complete . . . . . . . . . . . . . . . . . . .
11. Balance the central
heating circuit.
Complete . . . . . . . . . . . . . . . . . . .
12. Check the boiler in DHW
mode.
Complete . . . . . . . . . . . . . . . . . . .
13. Adjust DHW ow rate on
the boiler (if necessary).
Complete . . . . . . . . . . . . . . . . . . .
14. Make a combustion rate
with once pressing on
RESET button during 5 sec.
Complete . . . . . . . . . . . . . . . . . . .
15. Check the ionisation
current.
Complete . . . . . . . . . . . . . . . . . . .
16. Explain to the end user the
the boiler operation.
Complete . . . . . . . . . . . . . . . . . . .
17. At the time of commissioning,
complete all relevant sections of the
Benchmark Checklist located on the
inside back pages of this document.
Complete . . . . . . . . . . . . . . .
6. Measure the gas inlet
pressure.
Complete . . . . . . . . . . . . . . . . . . .