6
user’s manual
Ignition procedure
- ensure that the cock located on the
cold water fi tting is open
- ensure that the gas cock is open
- make sure the batteries provided
(1.5V LR20) were correctly inserted.
- Turn the knob between the positions
of minimum and maximum.
The device is ready to operate
By opening a tap, the device automatically
starts operating.
Note: If the device does not operate,
ensure that the gas and/or cold water
cocks are open.
Ensure that the device is electrically
powered.
Make sure the batteries were inserted.
When closing the tap, the device
automatically switches off.
Appliance power and Water temperature adjustment
The knob lets you adjust the water temperature and
power:
- Turn clockwise to increase power
and temperature
- Turn anticlockwise to decrease
power and temperature.
Switching off procedure
Turn the knob to OFF position to switch
off the appliance.
To switch off the device completely,
switch off and close the gas isolation
valve.
WARNING!!
Water with a temperature higher than 50°C
can cause serious burns.
Always verify water temperature before use.
To Next Page
Loading...
Need help?
General
