Planning and Installation manual VV600/VV602Plus 19
5.4.2. Mounting plate for welding VM604P
1. Remove paint or other surface finish from the area where the VM604P will be
mounted.
2. Fix the mounting plate into position on the surface and ensure that it can’t
move during the welding process.
3. Weld the VM604P mounting plate to the surface. First weld the points 1,2,3,4
then weld the seams 5 and 6 on the inside of the two slots, see illustration.
4. Mount the VV600/602Plus detector to the VM604P mounting plate, using the
three M4 screws supplied.
To Next Page
Loading...
