Planning and Installation manual VV600/VV602Plus20
5.5. Mounting of accessories
5.5.1. Recess mounting box VM602P and VM610P
For recess mounting of the VV600Plus in concrete, the VM602P/610P recess
mounting boxes are available. Not only will this accessory give a nice and tidy
installation but it also ensures a better coverage of the detector as it is anchored in
the reinforcement bars of the concrete.
For the best results, please follow the instructions below:
1. Select the exact location where the VV600Plus units shall be mounted and
make arrangements with the construction company to be on the construction
site when the concrete casting shutters are being put up.
Do not forget floors and ceilings !
2. On the pre-defined locations, drill two 7 mm holes in the panel and mount the
VM602P recess mounting box to the panel using the two M5 threaded pins
enclosed with the VM602P.
3. Fasten the bracket in the tapered hole on the back of the mounting box.
4. Weld the bracket to the reinforcement bars in the wall.
5. After completion of the mounting of the VM602P to the wooden concrete
shutter, introduce the conduits into the holes on the sides of the mounting box.
Seal the holes around the conduit, to prevent concrete from running into the
mounting box. Attaching the conduit to the reinforcement rods will prevent
them from falling out during the casting process.
6. Save the cover plate.
7. When the casting is completed mount the VV600Plus detector on the VM600P
mounting plate supplied with the VM602P.
8. After completion of the installation and a successful test, mount the cover plate
with the enclosed screws.
To Next Page
Loading...
