Ariterm Biomatic+ - Menu Structure; Main Menu and Core Settings; Adjustment and Accessory Menus; Power, Maintenance, and Heating Circuit Settings

ARITERM SWEDEN AB • ARITERM OY • Asennus ja käyttöohje • Installation och driftanvisning • Installation and operating instruction • 19.11.2009 • 11/32
MENU STRUCTURE
Ariterm Biomatic+ v090909
Temperature
Boiler Flue
gas
Burner off (on)
Auger external
manual
Menues
Adjustment
Operation time
Pellets store
Power settings
Heating circuit
Maintenance
Level monitor
Optical monitor
Test outputs
English
Default settings
Diff termperature
El step
Pellets store
Feeding factor
Consumtion average
Consumtion total
Auger external total
Alarm pellets min
Estimated time left
Heating circuit
Tachometer
Ash auger
Conv.cleaning
Residual oxygen
El 1 El 2
Total
OPERATING TIME
ACCESSORIES
PELLETS STORE
MENUES
ADJUSTMENT
MAIN MENU
High fan
Low auger
Low fan
Min auger
Min fan
High auger
Cleaning fan
Holding time
Auger external
Manual
Warmstart amount
Coldstart amount
POWER SETUP
Drop2
Drop
Fan
Auger burner
Ignition
El step
Shuntvalve
Auger external
Ash auger
TEST OUTPUTS
Conv.cleaning
Alarm
Run message
Cirkulation pump
Flow water max
Curve comp. 5 Curve comp. 0
Curve comp. -5
Curve
Cleaning
Ash removal
HEATING CIRCUIT
DROP
Start
Stop
Drop2
Start
Stop
Time
Drop
Temperature
MAINTENANCE
- Showing only when accessories are choiced in meny
- Showing all the time
Accessories
Shuntvalve 2
Adjust
Burner type
Coldstarts settings
Circ.pump stop
Drop
Time on
Time off
Time off
Time on
Residual oxygen
Fuel
Outdoor/Heat/Room
Heating circuit2
Start backup El
Power max
Power min
Temperature
High
Low
Min
Flow water min
Flow water min
Flow water max
Adjust
HEATING CIRCUIT2
Curve
Room factor
v091118