AZI Sales/Customer Service 800-528-7411 or 602-470-1414 or support@azic.com Page 17 of 26
To perform a test:
• If a clean pan is not already installed, then place a new/clean sample pan on the pan
support.
• Close the lid.
• If not at the Main Test screen, press
[ESC] repeatedly until the Main Test
screen is displayed.
• If the desired Test Program is not
currently active, press the [PROGRAM]
key, then highlight the desired Test
Program from the list.
• If desired, press [ENT] to view the test
parameters for the highlighted Test
Program prior to starting the test. Press
[ESC] when done to return to the TEST
PROGRAM SELECT screen.
• Press [START] to begin the test.
• The instrument will tare the pan. This
will occur instantly if the lid has been
closed and the balance has been
stable.
• Open the lid and quickly load the
sample, taking care to evenly distribute
it across the entire pan surface in a thin
layer to get the fastest and most
accurate results.
While loading the sample, the weight is displayed graphically with the acceptable
target window in green and in grams at the screen bottom. Add sample so that the
sample weight is centered in the graph; an audible signal indicates when the sample
weight is acceptable.
To Next Page
Loading...
Need help?
General
