What to do if the Arjo Enterprise 9000X Medical Equipment bed is beeping?
If your Arjo bed is beeping, it might be running on its backup battery. Ensure the power cord is properly plugged into a working electrical outlet. Also, check the fuse in the mains plug, if applicable.
Why is my Arjo Enterprise 9000X Medical Equipment bed difficult to maneuver?
If your Arjo bed is hard to move, check the brake pedals. If they are in the “steer” position, place them in the “free” position to allow easier movement.
What to do if the Arjo Enterprise 9000X mattress platform cannot be lowered?
If the mattress platform on your Arjo bed won't lower, it could be due to a height control software error. Try raising the mattress platform to its maximum height to reset the software.
What should I do if the Arjo Enterprise 9000X displays error code E300?
If your Arjo bed shows error code E300, it means a control button was pressed for too long. Remove pressure from all control buttons. If the error persists, you should contact an Arjo approved service engineer.
What does error code AES mean on Arjo Enterprise 9000X when the mattress platform cannot be lowered?
Error code AES, along with the inability to lower the mattress platform on your Arjo bed, indicates that the Anti-Entrapment system has been activated. Check and remove any obstructions from underneath the mattress platform. If the bed still won't lower, contact an Arjo approved service engineer.
Why are one or more functions inoperative on my Arjo Medical Equipment bed?
If some functions aren't working on your Arjo bed, they might be locked on the ACP (Auxiliary Control Panel). Unlock the functions on the ACP to restore their operation.
Why does the alarm sound when the patient moves on the Arjo Enterprise 9000X Medical Equipment bed?
If the alarm goes off when the patient moves on the Arjo bed, the movement detection threshold might be set too low. Try increasing the VariZone threshold setting.
Why are there errors in the indicated patient weight on my Arjo Enterprise 9000X Medical Equipment?
If you're seeing errors in the patient's weight on the Arjo bed, it could be due to an obstruction of the mattress platform. Check that the mattress platform isn't touching furniture, curtains, cables, etc. Also, ensure that weight hasn't been added to the bed without using the auto-compensation function.
Lists situations where the bed is unsuitable and its maximum load capacity.
How to use the brake and steering functions for bed mobility.
How to safely raise and lower the split side rails.
Procedure for emergency backrest lowering to facilitate CPR.
Overview of the caregiver control panel and its functions.
Controls for the bed's integrated patient weighing system.
Factors affecting weighing accuracy and precautions to ensure correct measurements.
Steps to properly initialize the weighing system before patient use.
How to weigh patients and use auto compensation for weight adjustments.
Common error codes and how angles are displayed on the weighing system.
Overview of the patient movement detection system and its sensitivity.
How to activate, adjust, and deactivate the VariZone movement detection.
Description and function of the anti-entrapment system sensors.
Instructions for cleaning and disinfecting the bed.
Daily and weekly checks to be performed by caregivers.
Table of common symptoms, possible causes, and corrective actions.
Further common error codes and their corresponding solutions.
General| Brand | Arjo |
|---|---|
| Model | Enterprise 9000X |
| Category | Medical Equipment |
| Language | English |
To Next Page
