23
Using a 2 point spreader bar (Loop
Sling)
Place the sling under the patient as if it were a draw
sheet (log-roll). Flex the patient's legs, and bring
the sling leg pieces under the thighs, attach the sling
to the spreader bar using any of the methods 1-3 in
'Lifting from a chair'. Alternatively the Maxislide
method can be used in this instance for sliding the
sling underneath the patient, if he/she cannot be log
rolled.
Using the soft stretcher
The soft stretcher is intended for use with the
stretcher frame and is available in two sizes, large
and extra large. It is also supplied in either plain
polyester or polyester mesh for washing use; both
types are available with or without commode hole.
To lift a patient using the stretcher frame and soft
stretcher proceed as follows:
Identify the head of the soft stretcher; a label sewn
to the head end will confirm this.
Position the soft stretcher sling as shown in figure 1
by rolling the patient as if inserting a draw sheet.
Ensure the top section of the sling (indicated by the
label attached to the sling) is under the patient's
head, with the top edge of the sling level with the
top of the head. With the stretcher frame as high up
as possible (but not to come into contact with the
patient, should it swing accidentally), move the
Lifter until the frame is directly over the patient, the
frame is symmetrical and can be used either way
round. (See fig. 2). Lower the stretcher frame
carefully over, and just clear of the patient, aligning
the center of the frame approximately over the
patient's navel. Connect all the sling loops securely
(See fig. 3). Note: The attachment straps have
several connection loops, choose whichever loop is
considered the best to enable the patient to lie in the
most comfort
able position. (See fig. 4).
When lowering the jib ensure that the patient's or
attendant's legs and feet are well clear of the
moving mast.
Warning:
Before the stretcher can be used
with the Hoist, ensure the Arjo stretcher
support frame has been correctly fitted to the
carrier. Once fitted correctly, the stretcher
frame should be able to rotate approximately
90° about its axis. Do not fit the stretcher
frame in line with the jib.
P1393a
Fig. 1
P1393b
Fig. 2
P1396d
Fig. 3
Warning: It is essential to keep the
patient at approximately normal bed
height to ensure stability of the unit and
without losing patient/attendant contact.
Warning: Only use soft stretchers that
have every attachment strap coloured blue.
Lifting from a bed
To Next Page
Loading...
