Table 2-8 MIPI 34 pinout table (continued)
Pin Signal name Pin Signal name
13 GND (1) 14 TRST_PD (2)
15 GND 16 nTRST
17 GND 18 DBGRQ
19 GND 20 DBGACK
21 GND 22 TRACECLK
23 GND 24 TRACEDATA[0]
25 GND 26 TRACEDATA[1]
27 GND 28 TRACEDATA[2]
29 GND 30 TRACEDATA[3]
31 GND 32 TRACEEXT (3)
33 GND 34 TRACE_VTREF
Note
1. Although these pins are typically grounded on the target board, the MIPI specification also allows
them to carry power. If they are connected to power rail (or rails) on the target board, these pins must
also be AC coupled to GND using 100nF capacitors that are close to the connector.
2. The TRST_PD signal allows the target board to have a second TAP reset signal which is normally
pulled-down. For more information, see the MIPI debug connector specification.
3. The TRACEEXT signal is not supported by DSTREAM-ST.
Note
Pin 7 must be removed for compatibility with DSTREAM-ST and MIPI specifications.
Warning
Using a non-shrouded header on the target board can lead to short-circuits or signal contention. To ensure
the correct polarity and position, Arm recommends that you use a fully shrouded box header.
2 Target interface connectors
2.7 MIPI 34 connector
100893_0100_06_en Copyright © 2017–2019 Arm Limited or its affiliates. All rights
reserved.
2-42
Non-Confidential
To Next Page
Loading...
