2.8 MIPI 60 connector
The MIPI 60 connector is a 60-way 0.5mm pitch socket which supports JTAG debug, Serial Wire Debug,
SWO trace, and up to 32-bit wide continuous-mode TPIU trace.
Typically, the socket is a QTH-030-01-L-D-A from Samtec.
Note
• DSTREAM-ST is only capable of capturing up to 4-bit wide trace (TRACEDATA[0-3]).
• The MIPI 60 connector supports separate voltage domains for the debug and trace signals. It is
necessary to supply the appropriate voltages to both of the VTREF pins.
• The MIPI 60 connector is not supplied with DSTREAM-ST, but is available on request. To request
one, contact Arm support.
• To use this connector with DSTREAM-ST, the supplied Mictor adapter must be used in conjunction
with both the Arm JTAG 20 debug cable and the CoreSight 20 debug cable.
Figure 2-7 MIPI 60 connector pinout
MIPI 60 pinout table
Table 2-9 MIPI 60 pinout table
Pin Signal name Pin Signal name
1 DEBUG_VTREF 2 TMS/SWDIO
3 TCK 4 TDO
5 TDI 6 nSRST
7 RTCK 8 TRST_PD (1)
9 nTRST 10 DBGRQ
11 DBGACK 12 TRACE_VTREF
13 TRACECLK[0] 14 RESERVED
2 Target interface connectors
2.8 MIPI 60 connector
100893_0100_06_en Copyright © 2017–2019 Arm Limited or its affiliates. All rights
reserved.
2-43
Non-Confidential
To Next Page
Loading...
