ARM DSTREAM-ST - Page 44

Table 2-9 MIPI 60 pinout table (continued)
Pin Signal name Pin Signal name
15 GND 16 GND
17 TRACECTL 18 TRACEDATA[19]
19 TRACEDATA[0] 20 TRACEDATA[20]
21 TRACEDATA[1] 22 TRACEDATA[21]
23 TRACEDATA[2] 24 TRACEDATA[22]
25 TRACEDATA[3] 26 TRACEDATA[23]
27 TRACEDATA[4] 28 TRACEDATA[24]
29 TRACEDATA[5] 30 TRACEDATA[25]
31 TRACEDATA[6] 32 TRACEDATA[26]
33 TRACEDATA[7] 34 TRACEDATA[27]
35 TRACEDATA[8] 36 TRACEDATA[28]
37 TRACEDATA[9] 38 TRACEDATA[29]
39 TRACEDATA[10] 40 TRACEDATA[30]
41 TRACEDATA[11] 42 TRACEDATA[31]
43 TRACEDATA[12] 44 RESERVED
45 TRACEDATA[13] 46 RESERVED
47 TRACEDATA[14] 48 RESERVED
49 TRACEDATA[15] 50 RESERVED
51 TRACEDATA[16] 52 RESERVED
53 TRACEDATA[17] 54 RESERVED
55 TRACEDATA[18] 56 RESERVED
57 GND 58 GND
59 RESERVED 60 RESERVED
Note
1. The TRST_PD signal allows the target board to have a second TAP reset signal which is normally
pulled-down. For more information, see the MIPI debug connector specification.
Note
• DSTREAM-ST only supports one channel of parallel trace.
• Pins marked as RESERVED might be internally connected in DSTREAM-ST, but are not currently
supported.
2 Target interface connectors
2.8 MIPI 60 connector
100893_0100_06_en Copyright © 2017–2019 Arm Limited or its affiliates. All rights
reserved.
2-44
Non-Confidential