SC-350/SC-360 – User’s Guide – 019223-101 Rev 06
9
Getting Started
a) Connect the power cord.
b) Switch On the machine.
c) The digit “8” will appear momentarily in all positions on the
display as a digit test.
After this the display shows the amount of coins counted since
the machine was last reset. The machine is now ready for use.
Continuous Counting
WARNING!
Risk of tipping!
Follow the safety Precautions.
a) Repeatedly press Q until the green
indicator goes out.
b) Set the diameter selector (a) and
the thickness selector (b) to their
desired positions.
c) Put the coins into the coin tray.
d) Press Start/Stop.
The machine starts counting and the display is continually
updated with the number of coins counted.
e) To stop the machine, press Start/Stop.
Add to memory
Press M to add the number of coins counted to the memory when
counting is finished.
The display resets to zero and the green indicator above ACC is lit,
indicating that something is stored in memory.
View memory
Press and hold ACC to view the contents of the memory.
Clear memory
Press C while holding down ACC to clear the contents of the
memory.
Reset
Press C to reset the display.
Note!
During the counting operation, check for rejected coins and put
any valid coins back into the coin tray.
To Next Page
Loading...
Need help?
General