SC-350/SC-360 – User’s Guide – 019223-101 Rev 06
10
Batch Counting
WARNING!
Risk of tipping!
Follow the safety Precautions.
a) Press Q several times to display the seven fixed
batch stops one after another.
b) Select batch stop and hold down Q.
The display shows the selected batch stop number on the left
and the batch stop quantity on the right, see also “
Modes of
Operation” on page 8.
The indicator above Q is also lit, showing that the machine is
set for batch counting.
c) Press B to check that the partial batch register reads zero before
starting.
If not, press B and C together to reset the register.
d) Press Start/Stop.
The machine starts counting and stops when the batch stop is
reached. The indicator above Q flashes when a full batch is
reached. When the machine is restarted, this register is
automatically set to zero.
–If there are more coins to count, press Start/Stop to
continue counting.
–If the last batch count is incomplete, shown by the indicator
above Q not flashing, press B to show the number of coins
in the bag (partial batch register). Press B and C together to
set the partial batch register to zero.
e) During counting check for rejected coins and put any valid
coins back into the coin tray.
f) To exit batch counting, press Q several times until the
indicator above Q is not lit.
Setting a Temporary Batch Stop
a) Press and hold Q while selecting batch
stop with M, ACC, B and C.
Each key changes the digit right above
it (M is used for two digits). The figure
“9” appears at the far left of the display,
showing that you are using a temporary
batch stop.
b) Release Q.
The machine is now ready to count the temporary batch.
c) Proceed to count the batch as described in “
Batch Counting”
on page 10, steps 2 to 8.
Note!
This temporary batch stop is not kept in the memory when another
batch stop is selected.
To Next Page
Loading...
Need help?
General