SC-350/SC-360 – User’s Guide – 019223-101 Rev 06
3
Installation
WARNING!
Risk of electric shock!
Follow the safety Precautions.
WARNING!
Risk of tipping!
Follow the safety Precautions.
The machine must be installed by an authorised
SUZOHAPP representative.
Caution!
The machine must be protected by a fuse or a circuit breaker
in the electrical circuit.
Caution!
Electrostatic discharge (ESD) may damage the electronic
components. All electronic circuit boards in the machine are
sensitive to ESD.
Please also note the following when installing the machine:
• Operating temperature 15–35 °C (59-95 °F)
• Operating humidity 30–80% RH
Do not place the machine close to any radiators. Make sure there is
free space around the machine to allow the air to circulate.
The socket-outlet shall be installed near the equipment and shall be
easily accessible.
If the plug on the supply lead to the machine has a fuse, make sure
it has the correct rating in amps.
Connect the machine directly to the Building Electrical Supply. Do
not use any mains extension lead.
Although this machine has been tested and complies with the
national and international standards/regulations, it is recommended
that no equipment which generates a high level of electromagnetic
interference (EMI) or vibration is placed close to the machine.
Positional References
Unless stated otherwise, positions and directions such
as left, right, upper, lower, rear, clockwise and
counter-clockwise are given with respect to the
machine when viewed from the front.
Warning Labels
To Next Page
Loading...