ARPEGE SECURITY SCAN COIN SC-350 - Page 18

SC-350/SC-360 – User’s Guide – 019223-101 Rev 06
13
e) Hold on to (d) while executing item 6 below.
f) Remove the screw (e) and turn (f) one half of a turn (180°), to
the position shown. Tighten the screw.
g) Release (d).
h) Replace the cover plate.
i) Lower the feed unit.
j) Close the inspection cover.
k) Set the diameter selector to 34 mm (max.) and test run some
tokens.
!"#$$!%#$$
e
f
d