Need help?Do you have a question about the ARRI ALEXA 35 and is the answer not in the manual?
General| Sensor Size | Super 35 |
|---|---|
| Dynamic Range | 17 stops |
| Base ISO | 800 |
| Internal Recording Media | Codex Compact Drive |
| Sensor Type | ARRI ALEV 4 CMOS |
| Resolution | 4608 x 3164 |
| Lens Mount | PL mount |
| ISO Range | 160 to 3200 |
| Recording Formats | ARRIRAW, Apple ProRes |
| Frame Rates | Up to 120 fps |
| Power Consumption | Approx. 90 W |
| Weight | Approx. 2.9 kg (body only) |
Describes REC/LOCK/User buttons, status LEDs, and side display/jogwheel.
Describes the flip-out monitor, its controls, and connectors.
Details camera power inputs and how to switch the camera on/off.
Details power outputs, total available power, and power consumption.
Explains how to navigate menus and the purpose of the HOME screen.
Describes FPS, TC, SHUTTER, EI, ND Filter, WB, and Status Section info.
Details the information displayed in the top status bar on EVF/SDI outputs.
Details the information in the bottom status bar regarding clip, status, timecode, etc.
Details overlay types like center marker, frame lines, electronic horizon, and their configuration.
Details project rate settings and assigning a camera index for identification.
Explains how to adjust shutter angle or exposure time.
Details how the exposure index affects sensor signal and LogC4 image.
Covers setting the built-in ND filter and white balance.
Explains timecode importance and Rec Run vs. Free Run modes.
Details Regen, Preset, Jam Sync timecode modes and manual setting.
Explains ARRI LogC4 encoding and VF/SDI processing options.
Covers drive LED states, media information, and MXF/ARRIRAW/ProRes codecs.
Explains how sensor mode affects frame rate and how to select recording resolution.
Explains methods to start/stop recording and the prerecording feature.
Details audio inputs (connector, internal mics) and outputs (SDI, headphones).
Explains how to enable audio recording and route audio channels.
Details SDI image output (clean/processed) and format settings.
Explains how to assign functions to camera, MVF-2, and accessory user buttons.
Explains how to synchronize the camera using Genlock or Timecode signals and sync shift.
Details updating camera software, MVF-2, and lens mount firmware.
Explains how to update LBUS devices, Codex Compact Drives, and PDM-1.
Explains how to save current configurations and load them later.
Details network connection options via Ethernet/WiFi and WiFi power/mode settings.
Details the white radio setup for wireless control and channel selection.
Explains lens motor calibration, torque, direction, and teeth count settings.
Provides warnings and steps for changing camera lenses safely.
Details lens mount types and adjusting EF lens iris.
Details how to use the Web Remote feature for camera control.
Explains CAP for remote control and the Camera Companion App.
To Next Page
