Need help?Do you have a question about the Art Pro VLA II and is the answer not in the manual?
Instructions for connecting the unit to mains power supply.
Information on connecting audio signals via XLR and 1/4" jacks.
How to set the threshold for signal compression.
Explanation of the compression ratio selection.
Controls the output signal level and acts as a balance control in Link Mode.
Adjusts the compressor's response time to signal level changes.
General| Channels | 2 |
|---|---|
| Maximum Input Level | +20 dBu |
| Sidechain Inserts | Yes |
| Input Impedance | 20k Ohms (balanced) |
| Output Impedance | 600Ω |
| Gain | 20 dB |
| Compression Ratio | Variable up to 20:1 |
| Attack Time | 0.25 ms to 50 ms |
| Release Time | 0.1sec to 3sec |
| Power Requirements | 100-240V, 50-60Hz |
| Dimensions | 19" x 1.75" |
| Metering | Gain Reduction |
| Dynamic Range | >100 dB |
| THD | <0.1% |
To Next Page
