Need help?Do you have a question about the Art HeadAmp 6 Pro and is the answer not in the manual?
General| Type | Headphone Amplifier |
|---|---|
| Channels | 6 |
| Input Impedance | 10 kOhms |
| Output Impedance | 51 Ohms |
| Gain Range | 20 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion (THD) | < 0.01% |
| Signal to Noise Ratio | > 90 dB |
| Connectors | 1/4" TRS, 1/8" TRS, RCA |
Retain safety instructions for future reference and heed all warnings on equipment and in literature.
No user-serviceable parts inside. Refer service work to qualified personnel.
Connect to mains power matching unit's type with a good ground connection.
Use provided plug, route cord to prevent damage, do not defeat grounding.
Ensure adequate ventilation and avoid exposure to rain, moisture, or liquids.
Avoid excessive heat, direct sunlight, dust, dirt, and smoke.
Handle with care to prevent damage; refer servicing to qualified personnel.
Install the unit according to instructions provided in the user guide.
Connect the unit to mains power of the type marked on the rear panel with a good ground connection.
Details pinouts for XLR, 1/4-inch TRS balanced inputs/outputs, aux, and direct inputs.
Describes front panel jacks, master volume, mono switches, bass, treble, balance, level, and power controls.
Details rear panel balanced inputs, thru, headphone outputs, and stereo aux inputs.
Illustrates a large-scale headphone distribution setup with multiple units.
Shows a monitor system with 'More-Me' foldback using auxiliary mixer inputs.
Details the three-year warranty against defects in workmanship and materials.
Lists conditions voiding the warranty, such as misuse or unauthorized alterations.
Provides steps for troubleshooting, contacting support, and returning units for service.
Space to record purchase date, place of purchase, and serial number for reference.
To Next Page
